Hi
Sorry to interrupt your discussion.
I just want to check my project(just algorithm) by simulator rather than emulator because it is convient espicially when i am not in our factory.
I have choosed F283x CPU Cycle Accurate Simulator and build my project.
But how can I run,halt,step_int and so on? All these buttons apear grey(not active).
And I can not watch the vedio mentioned above in
http://www.youtube.com/watch?v=ksYe_FFAlEM&list=PL41A6079DC06BB313
because youtube.com is not avalable in our country.................
Could you tell me what should I do next step by step? Thanks very much!
Gary