Thanks for all your help so far. I finally was able to connect to the microprocessor and to get my code working well however, as you predicted I’m having trouble scaling to the H2S 0 to 100ppm. What variables should I adjust to correct this error? I think I know which ones, but I might be missing something.
Best regards,
Nicole Stanton
Engineer
Pacific Northwest National Laboratory
902 Battelle Boulevard
P.O. Box 999, MSIN K5-17
Richland, WA 99352 USA
902 Battelle Boulevard
P.O. Box 999, MSIN K5-17
Richland, WA 99352 USA
Located in SEF Building
Office: 509-371-7980
Cell: 850-545-4579
From: Ajinder Singh [mailto:bounce-1411@mail.e2e.ti.com]
Sent: Friday, June 27, 2014 11:27 AM
To: analog_elab@mail.e2e.ti.com
Subject: RE: [Webench Tools Forum] Webench and the TIDA-00056 for an H2S Sensor
Sent: Friday, June 27, 2014 11:27 AM
To: analog_elab@mail.e2e.ti.com
Subject: RE: [Webench Tools Forum] Webench and the TIDA-00056 for an H2S Sensor
When I said change RTIA, i meant change TIA_GAIN (or the register 0x10) bit [4:2] to 100
You dont have to change RLOAD
[/collapse]