Ki,
Thank you for your prompt reply.
Yes, I was wondering how exactly I would have to alter the values of my registers (for example, how do I set the value of the CTRL register, say, to 5h?). I probably should have been more specific with my questioning, apologies.
Okay, so the way I understand it, I can reference by address without the header file, and the header file will enable me to use a name as a reference? In other words, I do not need any header file to access them using just the address, am I correct?
As far as the version of CCS goes, I shall do that!
Thanks again for helping out!
Regards
Madhsuudan