While knowing that I will need to modify the TIDA-00056 electronically is helpful, it had nothing to do with my question. According to the user manual (http://www.ti.com/lit/ug/snoa922/snoa922.pdf#page=12&zoom=auto,0,691.9) I am supposed to update the sensorservice.c file.
However, the Web bench (which is supposed to have those values is practically unpopulated).
Now either you are trying to tell me that the firmware needs no updating (in which I have been given the runaround to buy the debugger and to work with your firmware code) or there is information lacking to allow me to use your supposedly compatible hardware.
Lets make some easy questions then.
To use the H2S sensor from City tech the H2S 3E 100 with the Gas Sensor Platform known as the TIDA-00056 do I need to update the firmware?
If yes:
Where do I find the parameters for the Citytech H2S 3E 100 (and please don't say the data sheet because I've already looked there) to fulfill the parameters for the sensorservice.c file?
Do I need to remove Resistor 43 as was previously stated in your earlier email?
Please understand that I am trying to make the firmware work right now. Though if there is anything else that had almost no mention that I should know about, it would also be helpful.
Best regards,
Nicole Stanton