Hi
CCSv6.0.0.00190, ti.platforms.evm6472, stairstep example, System Analyzer 1.4.0.6, CGT 7.4.8, XDX 3.25.5.94, SYS/BIOS 6.37.2.27, XDS560v2 spectrum digital.
The .cfg is unmodified and states that its defaulted to the UploadMode_JTAGSTOPMODE mode. I built the project and loaded it on core 0, ran it, set breakpoints, and I believe its doing example code is stated to do in
http://processors.wiki.ti.com/images/7/7b/MCSA1.1_Getting_Started_Guide.pdf
I've stopped the core and go to Tools -> RTOS Analyzer -> Print and Error Logs and then the window pops up saying it "Cannot Determine" the instrumentation status
I clicked on the "Cannot Determine" and got the following
I selected OK and then Start. I then get
After clicking OK, CCS opens up a new window with Live Session and Printf Logs tabs. Both do not contain any data.
The .cfg is attached.(Please visit the site to view this file)
Complete project attached.
(Please visit the site to view this file)
So what am I doing wrong? Its an example project straight from TI's example repository loaded via the wizard.
Is there something I must do to my ccxml emulator configuration file to make this work?
In CCSv4, the messageQue example output print logs straight out of the box. I tried CCSv6's messageQue example also but get the same "Cannot Determine" error.
Cheers2u