Thank you gautam,
I'm making project on three phase energy meter based on msp430f47197 and I have used the same schematic as uploaded on TI's page...................
I'm using CCSv5.x and yes I've done all the things with importing other projects and also switching workspace...........
And main matter is what as included in source code when I debug the same code only using some instructions like "disable the watchdog timer and initialization of some sfrs it does not enters automatically in run mode and also allow to place some breakpoints......................
but as I try to add some other instructions as follows it behaves as before..............
Phase[0].Frequency=4999;
Phase[1].Frequency=4999;
Phase[2].Frequency=4999;
so plz help me to let me know that why this is being? and how these instructions are behaving that it does not respond to breakpoints.
how can I check that what is problem with the instructions plz write here........