Spent 3 days to wonder was loosing my mind but managed to work around ADC registers source stepping F5/F6 all appear cross wired in debug however behave correctly on the peripheral when disconnected from JTAG. ADC conversion data (even constant refresh) debug registers is reporting a higher value than when disconnected from XDS100v2 JTAG. Also like to report numerous crashes (Win7 program stop responding message) of CCS5.4 during debug load program flash when switching computer IP address to a local stealth and sharing data in the same memory space as debug with an Ethernet GUI while the Target was running as to verify & clear fault condition and test ADC measured analog voltage values.
Has this issue been fixed in CCS5.5 or was anyone else seeing this behavior?
Cross posted code and issue verified in Stellaris forum.
http://e2e.ti.com/support/microcontrollers/stellaris_arm/f/471/p/327865/1142783.aspx#1142783