Thanks Lisa for the Quick Info.
a) I want to use ccs IDE completely for the peripheral simulation like TCP/IP, SD Card, Ethernet along with SafeRtos without using any Hardware Board. Are all these possible on simulator itself? If not are there any other ways of getting it done. My main problem is that i do not have any HW/Board.
b) The second point is that i could see in .ccxml file few of the settings like . CortexM3 Device Cycle Accurate simulator under Texas Instruments Simulator and also Stellaris in-circuit debug interface which gets selected by default when i select for the target configuration at the start. May i know the difference between the two.
Regards,
M.Shradhanand