Hello,
I have a Blackhawk XDS560v2 System Trace on USB and a custom board based on EVM. Our project is quite large now but the problem I'm facing is that after I press Debug button, only once in three retries I can start the program from Run Program button, although the GEL file was executed so I have to exit Debug state and press Debug button again. Any idea what is causing that? If I run test jtag it reports success. Sometimes it reports some exception at IRAM address although my code is loaded into DDR. This firmware runs fine when booted from SPI flash so I don't think there's a bug in the code.
Best regards,
David.